Help splitting signal from 1 satellite to 2 receivers

[rrob311]

I have a couple of stationary dishes that I would like to split off and feed to another receiver across the house. Is there a way to do this without a dual output LNB? I understand that you have to view the same polarity but this does not matter because one of my dishes only has 1 polarity anyway. I prefer to not run a loop out on the primary receiver as it is already hooked up to another box.

 

[carlospr43]

you will need a 3x4 or a 4x4 and one diseqc for each box. If using a single LNB then you need to choose which polarity you want to download (13V for verticals and 18V for Horizontals). Here is a thread my friend anole did some time ago with differents configuration so you can take a look

http://www.satelliteguys.us/fta-mpeg2-faqs/134124-switch-setups-simplified.html