Help: UNsuccessful dish hookup to Hopper

[DennisTheSatellite]

PLEASE HELP !!
[FONT=&amp]I installed the Dish 1000.2 DPP Twin LNBF (Eastern arc) with one cable only.[/FONT]

[FONT=&amp]My Hopper keeps looking to Sat #3 but it has no signal.[/FONT]


[FONT=&amp]MY SETUP STEPS:[/FONT]

[FONT=&amp]1) I connected the one and only cable to LNBF port #1.[/FONT]

[FONT=&amp]2) Successfully aimed left lnb to 72 and right to 61.5 (good signal for each)[/FONT]

[FONT=&amp]2) Took cable completely off Hopper and ran ChkSW.[/FONT]

[FONT=&amp]3) Connected cable from LNBF into "Node Sat" #1.[/FONT]

[FONT=&amp]4) Connected "Node Host" out to Hopper.[/FONT]

[FONT=&amp]5) Ran CheckSW. [/FONT]

[FONT=&amp]RESULTS:[/FONT]

[FONT=&amp]"System Status": 72 has red bar, 61.5 field has no color[/FONT]

[FONT=&amp]Hopper's "Point Dish" shows 3 Sats. And it sometimes assigns a station to Sat 3# with the error message "no signal".[/FONT]

[FONT=&amp]I also ran a CheckSW >before< attaching the Node – same results[/FONT]

[FONT=&amp]Thank you, thank you for your help. :[/FONT]

 

[satnewb]

You need 2 cables from dish to node, then 1 cable to the Hopper.

 

[DennisTheSatellite]

You need 2 cables from dish to node, then 1 cable to the Hopper.

satnewb,

I truly appreciate you help and super immediate reply.

Very best regards,
Dennis...