It has been doing this for several hours, I did the soft reset using the red power button, did the hard reset by unplugging the receiver for a few minutes. After the Hopper 3 splash screen it displays Starting Up 9999 then reboots again and so on.
Anyone know what this is?
Not blinking and plug directly into an outlet.
Many times it's a heat issue, in a small enclosure....I am not familiar with the Hopper 3 high failure as your describing....It sure was for my VIP922!We are also experiencing this same Hopper3 rebooting issue. We are on our 3rd unit. I see several threads discussing this problem. Can anyone tell me how their issue was finally resolved.
Trouble seeing how it could be heat. It's sitting on an open shelf below a coffee table with open ventilation front, rear, top and sides. Power through a brand new surge protector and direct to the wall both. Maybe I need a UPS?
Well - No Joey connected. I do have an Ethernet to our router but that's all. HDMI to the TV. Sound bar connected to the TV via fiber optic.When I had many reboots I finally disconnected the coax on the Joey and the reboots stopped.
With the first 2 units, I had an EHD connected, permanently with #1 and just briefly with #2. Never with Hopper #3.My H3 rebooted 4 or 5 times in an evening, disconnected EHD and problem stopped.
LOL, too fast Internet!Status update. Tech Svc visit. Turned Bridging off since we have no Joeys. Shifted to wifi instead of Ethernet (tech says they have seen problems with Internet being too fast? )
Two hours later the resets started again.
Looks like we're heading towards Unit #4.
Yeah that is hilarious.... I guess the field techs are going to the same school as the CSRs....LOL, too fast Internet!
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?
We use cookies and similar technologies for the following purposes:
Do you accept cookies and these technologies?