Installation of a VIP222K using a 1000.2 Dish

RCS71

New Member
Original poster
Jun 5, 2012
3
0
Midwest
Is there somewhere I can get instructions on wiring.
I have a 1000.2 dish with a Proplus triple LNB.
I am not sure what lugs on the LNB to connect the coax to.

Also, I with my 222k i received a splitter that has 3 coax cables that connect to the receiver and one lug to connect the coax from the dish. Does a single wire from the LNB connect to this?

Thanks
 
That "splitter" looking thing is a separator and you need to use that at the back of the receiver. The two short cables connect at the sat in ports and the cable from the dish connect to the single port on the separator. Be sure to run a switch test.
 
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 1)