I installed Mercury II software Version 0151 and found the following problems...
In Menu/Antenna Setup
Press Red button to edit TP
-Can change TP Frequency OK.
-Can change TP Polarity OK.
-But when I try to enter a new Symbol Rate, the numbers on the screen do not change. However the numbers are actually being entered. If you press Edit TP and exit the screen, the numbers will have been entered OK.
Then in Menu/Antenna Setup/Positioner (Diseqc 1.2)
-The signal meters (S and Q) do not work the same as when I go back up one level to the Antenna Setup menu. I will be moving my dish and the receiver will begin to get a good signal, but the signal meter in the Positioner menu does not change.
I have a VBox II and can move my dish with the remote for the VBox II. So if I go up one menu level to Antenna Setup and move my dish with the VBox II remote, then the signal meters in this menu work OK and indicate that I am getting a good signal as the dish moves to the satellite.
So the Antenna Setup signal meters seem to work OK, but the signal meters in the Positioner menu do not work, or at least do not work sometimes, perhaps with weaker signals?
I reinstalled my previous software version (V0145) and these things are working again.
In Menu/Antenna Setup
Press Red button to edit TP
-Can change TP Frequency OK.
-Can change TP Polarity OK.
-But when I try to enter a new Symbol Rate, the numbers on the screen do not change. However the numbers are actually being entered. If you press Edit TP and exit the screen, the numbers will have been entered OK.
Then in Menu/Antenna Setup/Positioner (Diseqc 1.2)
-The signal meters (S and Q) do not work the same as when I go back up one level to the Antenna Setup menu. I will be moving my dish and the receiver will begin to get a good signal, but the signal meter in the Positioner menu does not change.
I have a VBox II and can move my dish with the remote for the VBox II. So if I go up one menu level to Antenna Setup and move my dish with the VBox II remote, then the signal meters in this menu work OK and indicate that I am getting a good signal as the dish moves to the satellite.
So the Antenna Setup signal meters seem to work OK, but the signal meters in the Positioner menu do not work, or at least do not work sometimes, perhaps with weaker signals?
I reinstalled my previous software version (V0145) and these things are working again.