I have a 10' Mesh, the arms were uneven and measured bend to bend on 1/2" EMT conduit of 41 3/8" length... Now I have read and found my F/D... My intersection point of the strings to the back of the satellite (reflector) is 25 inches this would be d. Therefore F= (120*120)/(16*25) which equals 36 inches.
So, how to determine the proper length? Do I measure 36 from the back of the reflector to the tips of the scaler ring? to the back of the scaler ring?
I know this question may be bizzare but I really have tried very hard to find and solve my issues and so far have only been a "fizzle" of failure...
ANY assistance is GREATLY appreciated!!!!!
So, how to determine the proper length? Do I measure 36 from the back of the reflector to the tips of the scaler ring? to the back of the scaler ring?
I know this question may be bizzare but I really have tried very hard to find and solve my issues and so far have only been a "fizzle" of failure...
ANY assistance is GREATLY appreciated!!!!!