ProgDVB help

[reanimator]

I have a 30 inch hotdish and a sg2100 motor and running nexus-s a ku lnb. I have set the dish to the furthest west sat I could get a signal at using my channel master sig meter. I went and turned on progdvb and went to scan transponders. I went through the entire region of sats in the transponder section after I updated all the North American ones but I can't get a signal on any of them

 

[reanimator]

OK I am at my wits end. I move the dish just a little bit each time and when I get to the next strong signal on the sat meter I go in and scan all the sats in progfinder 2 and mytheatre and progdvb and the best I can get is a faint signal in progfinder 2. I have no problems with any hardware from the coax to the computer cause the two little 18" dishes with a diseqc switch gives me good reception.