I just bought an SG2100 from sadoun.I install it on a plumb pole and i have the fortec 1.2 meter dish.I set my true south which is telstar 5.My lat=36.1n my long=94.1w.I set the latitude on the motor to 36 and i set my dish elevation to 24.I went into my setup of my pansat 3500 and chose telstar 5.I put in my long and lat numbers.I chose ucals and go to reference which was zero and then i hit move 3.3 degrees.The motor went all the way to the west on the motor and stopped.I tried to manually make the motor go back east but it will not move.I did a reset and it still will not move.The green light is on the motor but i cannot get it to do anything.Anyone with a suggestion