under eave mount?

[hotshot12345]

Hello. I'm planning to mount a 90cm dish. Which mount would you recommend? Thanks

 

[SatelliteAV]

This is one of the best I found, so we carry it!

Works great on 90cm dishes as long as the rafter tails are structurally sound and solid.

http://satelliteav.com/p/shop/?ws_pid=624&ws_cat=470

 

[hotshot12345]

What about the universal eave mount and then attach a J-pole to it? It says only for DBS dish but should be OK for 36" FTA dish too right?

VMP DBS Gable Mount (GEM-1) from Solid Signal

 

[SatelliteAV]

What about the universal eave mount and then attach a J-pole to it? It says only for DBS dish but should be OK for 36" FTA dish too right?

VMP DBS Gable Mount (GEM-1) from Solid Signal

I wouldn't hang a 36" on a single rafter tail. This bracket is too lightweight and also provides no lateral support. It would not provide adequate support and your dish would dance like a kite in the wind and ultimately damage or weaken the eave.

36" dishes have quite the wind load. I would have a two if not a three point mount when mounting under the eave. A rafter often needs additional blocking to add the necessary rigidity to support these larger dishes.