Thanks everyone for the replies, I'm pretty sure this project will be a go, so I'm going to put in the extra pole for it. Turbosat, i swear that I'd found the thread of your build a couple of nights ago but I just looked for it again and couldn't find it. Thanks for mentioning the tilt, I hadn't thought much on that, looking at the polar ring again and the angles made me think the dish probably wouldn't be able to tilt down far enough the way I'd envisioned mounting it. Thinking now that I may use a nice looking mount that I have from an old pizza dish welded onto a bracket on the polar mount to give me room for adjustment and go with 1 meter for the dish. You probably saved me a lot of headache mentioning tilt, thanks. Sorry Anole, I probably should've explained a little better my goal, a bigger Ku dish than what I now have, 76 cm. I could definitely afford to buy one or probably find a used one if I looked hard enough, as has been suggested. I figured I already have all this stuff and it'd probably be fun to do and the motor I'm thinking would work better than anything I could buy for a Ku setup. I have the welding equipment and metal, I have a few lnb's just hanging around doing nothing, a couple of receivers, the polar mount, a bunch of pizza dishes I've picked up here and there even though they're pretty much useless, I've got pretty much everything I need to do this, I think. Except a vbox/gbox for the motor, like you mentioned. The motor I have does have a broken housing but still runs, but it looks to be an aluminum housing so I should be able to tig weld it back together. Speaking of motors, vbox/gbox, is there a major difference between the two, or are they both pretty much the same thing?