This is a mobile optimized page that loads fast, if you want to load the real page, click this text.

Ajak Motor proper maintenance

V

Vintagesports

SatelliteGuys Pro
Original poster
Nov 8, 2011
172
127
PR
Anyone know how to properly maintain an Ajak motor? It has a screw on top. Should I put some kind of grease through it? Does it need to be cleaned first from any old lube or do I just apply in it new grease? It seems to be working fine but does it need to be greased or lubed now and then?
 
No maintenance required. Don't touch that screw! It adjusts the primary worm drive inside the motor.
 
If you want you can remove the reed switch cover plate (three screws) under that is a magnet wheel. It is held onto the shaft with friction. You can grab the wheel in the center with a pair of pliers and pull it off. Under that is that primary worm gear drive. You could put some grease in there. Not too much.
 
Reactions: norman881, Titanium and KE4EST
pats said:
Hey I want that motor hevy duty were can I get one for sale motor only
Click to expand...
There are not too many of these out there nowadays. Maybe with some luck you can find one attached to a HH cband dish. I was actually very very lucky to find one in Puerto Rico.
Good Luck!​
 
Reactions: FTA4PA
You must log in or register to reply here.

Similar threads

P
Ajak motor with 5 magnet for reed sensor
Replies
9
Views
2K
Trust
C
AJAK Polar Mount and Reed Switch
Replies
22
Views
4K
arlo
R
Need Help - Paraclipse 12 F Von Weiss Motor Gera outside Board
Replies
5
Views
1K
stogie5150
S
Horizon to horizon motor issue
Replies
11
Views
2K
arlo
V
AJAK Super Tracker
Replies
2
Views
1K
Magic Static
M
Menu
Log in
Register