Connect the sensor wires ( S1 & S2 ) to terminals 8 & 9 ( Pulse & Ground). It doesn't matter what order. Connect the motor wires (M1 & M2) to terminals 10 & 11 (M1 & M2) If the motor runs west when it's supposed to go east just switch the M1 and M2 wires.
DX Antenna DSB-400 Positioner
- Thread starter espaun206
- Start date
- Latest activity Latest activity:
- Replies 46
- Views 7K
-
ENJOY SATELLITEGUYS AD FREE THIS FEBRUARY!
Thank you to the very generous support we got from our members in December we have decided to make the month of February AD FREE for everyone!
We want to see the true speed of our site and enjoy SatelliteGuys the way it was meant to be enjoyed!
If you would like to help us keep the lights on and keep enjoying the site AD FREE consider becoming a PUB MEMBER by CLICKING HERE.
THANK YOU TO EVERYONE FOR YOUR SUPPORT!
I've seen several members using vintage equipment as a dish positioner. In case anyone's interested, I have a Uniden Ultra complete with the remote. There is no VCII module, and the back cover for the VCII module is missing. I had it hooked up about a month last summer to move the one dish I have that's still movable until I found a couple UST-300 dish positioners and remotes.
If anyone's interested, I'll take $25.00 above the cost of shipping and it can be yours. The only reason I'm asking an additional $25.00 is because I could not find the remote that came with it, (probably sold it), and had to purchase one from a local installer before I could use it. I was darn lucky to find an original Uniden remote for this unit at any price. I have some others, but I haven't had time to dig them out and test them.
If anyone's interested, send me a PM and we will work out the details.
If anyone's interested, I'll take $25.00 above the cost of shipping and it can be yours. The only reason I'm asking an additional $25.00 is because I could not find the remote that came with it, (probably sold it), and had to purchase one from a local installer before I could use it. I was darn lucky to find an original Uniden remote for this unit at any price. I have some others, but I haven't had time to dig them out and test them.
If anyone's interested, send me a PM and we will work out the details.
The sensor wire shield drain wire (bare wire inside the foil shield around sensor S1 / S2 wires), should be connected to the far right terminal labeled SH. The shield drain wire should not be connected on the other end (out at the actuator).
Similar threads
