fortec & QHP=031 installation

[bbanin]

hello sat guys
i need help!!! trying to install a 30" fortech w/motor and a QHP-031 lnb. just don't know what to do. i guess the first question is: will this lnb support 2 receivers??at the bottom of lnb it has 4 outlets L C L C. i think one has to go to motor and the other to liner lnb side. then i have the other 2 outlets L & C i have a diseq switch that has 4 in ports and 1 port to the receiver. any help would be appreciated or direction you could point me to.

thanks
bbanin

 

[brentb636]

Check out this thread in the FAQs section.
http://www.satelliteguys.us/fta-mpeg2-faqs/134124-switch-setups-simplified.html

You'll see a post or two , with diagram, of the QPH031 setup with a Diseqc switch.
Thanks to our lizard friend, Anole.