Glorystar Updates

Gary Z

SatelliteGuys Pro
Original poster
Jun 27, 2005
942
0
Seguin, Texas
I have an interesting problem with my GEOSATpro DVR1100c. On Monday nights when the receiver updates it turns itself on. I press the power button on the remote and turn it back off and 10 seconds later it turns itself back on. Press the power button again--turns off then back on about 10 seconds later. It happens in Glorystar mode and Advanced mode. I power the switch in the back off/on and it all works fine again until the next update. When I had it in Advanced mode I left the OTA ON otherwise it would lose time.
 
It is after the update is completed. In fact when the update comes in I am asleep and the next morning the receiver is on. I never interrupt the update, I should have been more clear.
 
Thank you for the clarification. We have never observed this operational issue after an update.

We would recommend performing a Master Reset. This will reload the current firmware from flash and delete data from unused memory blocks.
 
***

Users Who Are Viewing This Thread (Total: 1, Members: 0, Guests: 1)

Who Read This Thread (Total Members: 1)