Sounds like you have no MS , the wires go from the LNB to a ground block and then into the rec's.
If you only have 1 rec set up then you have no need for a MS.
Just curious, go out and check to see if your connections at your ground block are tight as well as behind the rec.
Did the installer run NEW runs or use existing runs ?
Jimbo
Yup everything is tight from block back towards the receiver .. he used one existing run and created a new one ... however "searching" errors are happening on both tuner one and tuner two ... the existing run was installed around two years ago for my Dish setup ... has always been solid ... I'm sure he will start from the receiver and work his way up when he gets here - i hope he does not just replace one of the connections on the receiver and tell me to cal again i it goes bad ... hopefully it'll go out again before he gets here
