When I turn on microwave, oven, or garage door opener I lose all even transponders!!! What is causing this???
lose all even transponders
- Thread starter wadethecableguy
- Start date
- Latest activity Latest activity:
- Replies 6
- Views 1K
- Status
gremlins.....gotta be gremlins
i did some google searching for results for loss of even transponders.
turns out Iceberg was correct... however they refer gremlins as to little green men.
bastards.
id say maybe bad LNB perhaps?
im going with the circuit theory, i would try and run an extension cord with surge protector to another room that you know for a fact is tied to a different breaker. it could also be a grounding problem...
OK I meant to say odd transponders. Dont know if that makes a difference though. I'll checkout the circuit theory. Thanks for ya'lls help. Even you Iceberg!
Are you losing channel or just transponder signal meter readings? When do they come back?
See if you can produce the same effect with a long extension cord to another electric circuit. Does this happen on all receivers?
Odd or even is probably not significant but transponder loss, odd or even, is usually a fitting or cable and then a defective LNB port.
Interesting case!
Joe
See if you can produce the same effect with a long extension cord to another electric circuit. Does this happen on all receivers?
Odd or even is probably not significant but transponder loss, odd or even, is usually a fitting or cable and then a defective LNB port.
Interesting case!
Joe
Last edited:
- Status
