motor and switch setup

[drhcanada]

just setting up a motorised system to complement my current stationary dish farm and was wondering if there is a better setup for my 5 LNBs then the on included in the quick picture I have included.

equipment:
Receiver: VS9000
Motor: SG2100
Diseqc: Chieta Heavy Duty
22KHz: Ecoda
LNBs: 4 linear, 1 circular (119)

will the diseqc / 22khz setup interfere with anything since the motor is in the mix now? also anyone getting the vs9000 to work properly with USALS?

 

[Anole]

Should work fine.
You can expand each of the diseqc inputs with any 22khz switches.
Or, you could put the Ecoda ahead of two diseqcs, and have an eight-input array.
Not really any better; just another way to give you lots of room for expansion.

Always remember to power down your receiver when connecting or disconnecting any hardware to the switches.