My 4x1 DiSEqC switch is responding for both committed and uncomitted switch commands

Status
Please reply by conversation.

mohanaprakash

SatelliteGuys Family
Original poster
Oct 7, 2008
36
0
Hi

I am having a DIGIWAVE GD-41A DiSEqC 4x1 switch, i am using the following DiSEqC message to select the switch position, for the below message switch is working properly.

Position Message
1 e0 10 38 c0
2 e0 10 38 c4
3 e0 10 38 c8
4 e0 10 38 cc

I found that switch selection is working properly even i change my command byte as 39 (uncommitted switch), i don't know whether this behavior is correct or not.

Also i having one DIGIWAVE DGS-SW8x1 switch i am using following DiSEqC message to select the position

Position Message
1 e0 10 39 70
2 e0 10 39 71
3 e0 10 39 72
4 e0 10 39 73
5 e0 10 39 74
6 e0 10 39 75
7 e0 10 39 76
8 e0 10 39 77

For these command my 8x1 switch is working fine.

But the interesting thing is, if connect a 4x1 switch in DiSEqC bus and i send the below messages position 2 is selected in 4x1 switch.

e0 10 39 74
e0 10 39 75
e0 10 39 76
e0 10 39 77

Can some one tell whether this behavior is correct or not.

Regards
Mohanaprakash
 
I am writing a software for DiSEqC 1.2 support, while testing my software i found this behavior.
 
Status
Please reply by conversation.

Scanning, double channels, dual c band

SW21 switches

Users Who Are Viewing This Thread (Total: 0, Members: 0, Guests: 0)

Who Read This Thread (Total Members: 2)