I read Saduans' installation guide for the motor, I am a little confused.
I am pointing at amc5 60% signal and qaulity.zip is 26149
My Motor is on "0" (middle default)
I have a traxis receiver.
My pole is level, plumb
My line of site is completely clear.(my sat is in a field with the nearest obstruction 400yards away.)
Now, how do I get other satellites with the use of the motor?
Should I be pointed at true south or my southern most sat?
Is there anyway to tell what my furthest eastern and western sats are that I can pick up?maybe I can try calibrating those to insure that I am hitting the arc.
Do the #'s on the motor equal degrees or what? can I use those #'s to figure how close I am to specific sats? gallaxy 10r for example
I was thinking I would be able to move the dish from inside at this point, or must I program in all of the satellites before I can actually use the motor from inside?
I have been reading alot and Suduans' guide for the motor hook up lost me at the point of calibrating the receiver, motor, and arc.
Thanks
Charles Poole
I am pointing at amc5 60% signal and qaulity.zip is 26149
My Motor is on "0" (middle default)
I have a traxis receiver.
My pole is level, plumb
My line of site is completely clear.(my sat is in a field with the nearest obstruction 400yards away.)
Now, how do I get other satellites with the use of the motor?
Should I be pointed at true south or my southern most sat?
Is there anyway to tell what my furthest eastern and western sats are that I can pick up?maybe I can try calibrating those to insure that I am hitting the arc.
Do the #'s on the motor equal degrees or what? can I use those #'s to figure how close I am to specific sats? gallaxy 10r for example
I was thinking I would be able to move the dish from inside at this point, or must I program in all of the satellites before I can actually use the motor from inside?
I have been reading alot and Suduans' guide for the motor hook up lost me at the point of calibrating the receiver, motor, and arc.
Thanks
Charles Poole