Hi all,
I use a setup like this one
to connect my LNBs from my BUD to my PCI card via a 4 ports Diseqc switch. My Circular LNB is connected to port #1, the linear Ku to port #2, and finally the C Lnb to port #3. The ports #1 and 3 are working just fine. However, I get no response at all from the port #2 (linear Ku); I tried with the last one (port #4) and same result: no response. But when I connect the linear Ku directly to the PCI card (without the switch, but after splitting) the signal is OK, and I can lock channels.
Can someone here suggest one or two things to check to pinpoint the source of this strangeness ?
Mike
I use a setup like this one
to connect my LNBs from my BUD to my PCI card via a 4 ports Diseqc switch. My Circular LNB is connected to port #1, the linear Ku to port #2, and finally the C Lnb to port #3. The ports #1 and 3 are working just fine. However, I get no response at all from the port #2 (linear Ku); I tried with the last one (port #4) and same result: no response. But when I connect the linear Ku directly to the PCI card (without the switch, but after splitting) the signal is OK, and I can lock channels.
Can someone here suggest one or two things to check to pinpoint the source of this strangeness ?
Mike