I recently purchased another dg-380 (I had another dg-380 that has since been donated to a friend and the reason that I have these replacements). The previous configuration worked like a charm to drive the motor via usals and mytheatre. However, I have not had quite the same experience with the second set of hardware. It seems that every once in a while one of the horizon limits (usually the westerm limit) get set on the sat that i am currently tuned to. For example i will dial up some feed on H2 74w but when i go to drive the motor back to lets say g18 the motor goes nowhere as the western limit as somehow been magically set to 74w. The only way that i have found to get the motor back to normal operation is to go physically reset the motor. The first time this happened I thought that this was just some fluke but as time has gone on it seems that it happens with greater frequency. I was hoping to try switching my usb card to the new dvbworld 2104 that i have to see if the problem comes from my current card but the dvbworld doesnt work with usals and mytheater (at least this is my experience but that is a whole other thread). Would anybody have an idea where the problem is?