I have an SG2100 motor hooked to my 36" dish and just yesterday I've been having a problem where if I got west of 110 and then say try to come back to 97, the motor goes a degree or 2 and then stops without continuing beyound to arrive at 97 etc.
I can however chose the send motor to centre command and it goes to south, but once I pass 97 it wont come back without manually going back to south.
Have tried resetting the motor and receiver and swapping the receiver for another and still the same issue.
Anyone else have any suggestions or is this a bad motor?
thanks
I can however chose the send motor to centre command and it goes to south, but once I pass 97 it wont come back without manually going back to south.
Have tried resetting the motor and receiver and swapping the receiver for another and still the same issue.
Anyone else have any suggestions or is this a bad motor?
thanks