I was wondering if I can control more than one motor using a DiSEqC 1.1 switch (Digiwave 8 in 1, DGS-SW8x1). What I want to do is control a 3ft dish with a Universal Ku band LNBF, and a 4ft dish with a C band LNBF (C band small dish project), because I already have all this hardware, and didn't want to purchase a C/Ku LNBF if I didn't have to. I removed my Ku lnbf and tried the C band with my 3ft dish and motor and it worked (with a little tweaking, it would over shoot the satellites at 1st if I used the same settings I had with the Ku lnbf). I have another motor that I can use on the 4ft dish, but I didn't know if I could use 2 motors on the same receiver, and didn't want to risk damaging the receiver. I have the x2 Premium HD Special Edition receiver. Any ideas?