Dish: slimline 5, Non-SWM. Simple set up. 3 coaxs in; 2 to a HR21 and one to a H20. Nothing else. Am trying to replace a H20 with a H24 that was recently (last week) used on a SWM system. Much smaller and fits area better. I changed the config to Slimline 5 and multiswitch. The H24 never can verify the configuration and I continually get error 771A messages. Have reset H24 a number of times. H20 works fine on that coax. H24 works fine if put back on a SWM system. Am using BBC when on non SWM.
Any ideas??
Any ideas??