RE: "Go To" commands. Now that's a topic I've got a b%#ch about. These Micro HDs I have give me a fit when I'm trying to fine tune a channel as if you wait more than a few seconds between "bumps" one way or another it takes off back to the position were on, or sometimes just heads off on it's own somewhere else?? I like to tweak mine on a channel by bumping the dish until I get the "no signal" message, then bump back until I get a picture, record that number on the motor controller then run past it in the other direction and come back to get a number. Once I have position numbers from both ends I take half of the difference to set that particular satellite location. That Micro HD gives me a fit as it's continually trying to run back to the sat location. I actually burnt up a VBox X doing that a few years ago as it fried a relay in it.
Another thing I don't like is when you look at the satellite menu it doesn't offer you an option to look at the actual channels on that satellite before you run to it??? I don't know about you guys but I can't remember the exact location of all the stuff I watch, hence the desire to be able to SEE what's on a particular satellite BEFORE I go to it.
OK, that's enough thread hijacking. I'm done for now.