It has been a few years since I have bought an FTA receiver so I cannot remember how to set up my dish. I have 55 % Signal but no Quality at all. How do I get the quality needed in order to get any channels? This question may have been asked before, but I did not see it. I apologize if this is a repeat question.
Openbox Decent Signal/No Quality
- Thread starter #1 KY Wildcats Fan
- Start date
- Latest activity Latest activity:
- Replies 3
- Views 1K
- Status
Welcome to SatelliteGuys!
First you need to make sure your settings in your receiver match the LNB(F) you are using.
Next you need to have a valid and current known active transponder entered in for the satellite you are trying to hit.
What equipment do you have? Dish? LNB(F)?
What satellite are you trying to hit?
First you need to make sure your settings in your receiver match the LNB(F) you are using.
Next you need to have a valid and current known active transponder entered in for the satellite you are trying to hit.
What equipment do you have? Dish? LNB(F)?
What satellite are you trying to hit?
Sorry this site does not condone the hacking of Dish Network or hacking period for that matter. If you wish to discuss TRUE FTA, you are welcome to start a new thread, otherwise you will need to look elsewhere.
- Status
