I have a major problem. I was hooking up a new 3x8 multiswitch so i could run an extra line to my tivo. Well I hooked everything up right and came into the house to check. All transponders were showing good readings (90's -100) so I went back outside to put everything back under the house. When I came back in, I was horrified to see "Searching for Satellite Signal on my TV. I did a Test if the signal and all the Even ones had good readings (90's-100), but all the even ones were 0. I went outside to check all connections and everything was good. I checked the ends of the cable to the multiswitch and to the dish. All good. I then went back and I still had the same problem. I so changed the multiswitch back to the 3x4 and went back into the house. Still, nothin. Please help. What is wrong with my satellite? It is like that on all of the channels.
I have a dual lnb dish running into a 3x4 multiswitch going to 4 tv's. Please Help!!!
PS. I was getting half the channels on all tv's so I thought maybe if I unplug the recievers for 15 seconds and plug them back in maybe that will fix it. I WAS WRONG!!!!! Now none of my recievers will boot up and I have NO TV!!!! AAAHHHH!!!!
I have a dual lnb dish running into a 3x4 multiswitch going to 4 tv's. Please Help!!!
PS. I was getting half the channels on all tv's so I thought maybe if I unplug the recievers for 15 seconds and plug them back in maybe that will fix it. I WAS WRONG!!!!! Now none of my recievers will boot up and I have NO TV!!!! AAAHHHH!!!!