Intelsat 5 Hor. &Ver polar.

[a_savvin]

HI,
I installed my dish with viewsat fta receiver.
For some reason I can find/see only channels with Vertical polarization.
Thanks

 

[Hermitman]

Check and make sure your receiver is properly set up for the type of LNB you have. You may not be sending the proper switching voltage to the LNB.

 

[a_savvin]

I have Telstar 5 97W
LBN power ON
LNB Type Standard
LNB high 10750
22 hgz off

 

[taelon721]

HI,
I installed my dish with viewsat fta receiver.
For some reason I can find/see only channels with Vertical polarization.
Thanks

Is this a newer dish you bought? Just making sure you are not using an old Primestar dish (which most split the Polarity).

 

[a_savvin]

Hi I have digiwave DigiPro 75CM(33\") Dish

http://www.digiwavetechnologies.com...op=view_page&PAGE_id=172&MMN_position=183:174

and i beleive this head DSS Single 11250 LNBF--DG890D

http://www.digiwavetechnologies.com...er_op=view_page&PAGE_id=18&MMN_position=39:25

 

[Gary Z]

a_savvin if you are using a Primestar LNB that could be the reason why you are getting only vertical channels. The Primestar LNB's will also work using a switch.

 

[Das Hammer]

and i beleive this head DSS Single 11250 LNBF--DG890D

http://www.digiwavetechnologies.com...er_op=view_page&PAGE_id=18&MMN_position=39:25

Looks like an lnbf for circular polarity. Especially with the 11250 lof.

Are you sure that's the right one?

 

[a_savvin]

HI,
Looks like i have to use switch. I just change head connector to another one and I was able to get H polar.
Thanks a lot

 

[voomvoom]

You have the wrong lnbf for IA5. That lnbf is a Circular lnbf. You need a Standard lnbf or a Universal lnbf.

Al

 

[voomvoom]

Hi I have digiwave DigiPro 75CM(33\") Dish

http://www.digiwavetechnologies.com...op=view_page&PAGE_id=172&MMN_position=183:174

and i beleive this head DSS Single 11250 LNBF--DG890D

http://www.digiwavetechnologies.com...er_op=view_page&PAGE_id=18&MMN_position=39:25

That can't be the lnbf you have, if you're on IA5 and you're getting any channels. If it is? I'm scratching my head!

Al

 

[a_savvin]

i think i have standard single LNBF 10750.
I already installed it, so i couldnt reach head to read label on back side of head.