Motor movement issue

[jself1982]

Ok, I have a stationary dish for G10ku through port 3 on my switch, and my motorized dish is on ports 1/2 for Lin/Cir...my motorized dish used to not move when I would go from AMC 6 to G10ku because G10ku is on the stationary, now, I'm getting the signal from the stationary dish like I am supposed to, but the motorized dish is moving to G10ku as well when before it would not move to G10ku? Does anyone know why it started moving?

 

[SatinKzo]

Did you happen to set any motor options for G10? I have a similar setup (almost exactly the same switch wise and motor).

When I switch from say AMC3 to G10, no motor movement, but I also have the motor options for G10 set to none on my receiver. If I set it to USALS or Diesc, then eventhough I have g10 on port 3 and it's a stationary dish, the motor will move also to G10

 

[jself1982]

You know what, I will check that in the morning, I may have it setup to move...thanks for the help!