Starband dish, LOS issue to 129

Because of surrounding trees, there is not a position on my roof or anywhere near my house which has LOS to both 110/119 and 129. If another dish is mounted where LOS isn't an issue with 129, could it be used with a switch and my Starband dish which is not used for internet? I currently receive a few HD channels on a 211k from 110. If this is possible, which components would work and about how much will they cost?

A guide I found
http://www.satellitetv.com/downloads/dishmanuals/SHOW_949_dishpro_install.pdf
shows a Dish 300 with a Dish 500 and a DP34. The Dish 500 may be similar to the Starband dish because it is either detected as or is configured to be a 500 in the 211k.

Thanks for your help.
Ben

Pictures of the Starband Dish and Dish components on the back are attached.

LNB and switch model

Thanks, scoobyxj. There are two cm # 3041206-01 model # bsna5-507A LNBs shown in the following url on the dish arm

CP Electronics: LNB DUAL - DTV DISH - CIRC - JAPAN DBL-CM, LNB'S, BSNA5-507A

and two Dish SW21 switches on the back.

Would the switch be damaged if these LNBs were connected to the new switch and were not DishPro compatible?