technical question about 3D2LNBR0-02

  • Thread starter Thread starter PE2BZ
  • Start date Start date
  • Replies Replies 0
  • Views Views 15

PE2BZ

New Member
Original poster
Aug 6, 2025
1
0
the Netherlands
Hi,
short introduction, I am Ben, radio amateur from the Netherlands ( Callsign PE2BZ ) and I like to find orbiting satellite signals and identify them with the use of strf tools.
strf tools

For now I have received signals up to 3400 MHz and the beacons from starlink in the KU band.

I am now trying to receive orbiting signals in the KA band, 18 GHz, for amazon / kuiper satellites.

I started with CoPilot about the LNB with model number 3d2LNBR0-02 and the usability to tune into 18 GHz with IF output to an SDR (HackRF and Adalm pluto available) which suggested that for this LNB I had to power it with 21 Volt DC and 22 kHz inserted to switch to the 18 GHz RHCP polarity.

Now, after ordering the LNB from the US of A and checking with copilot again it tells me I need some special command to send to the LNB to have it switch to that frequency which has to be sent from a directtv receiver which I don't have.

Is there any documentation which describes how I would manually be able to set the LNB to my preferred frequency range ?

Thanks for your time,

Ben
 

GTMedia V8 Finder 2 For SAT ID

Users Who Are Viewing This Thread (Total: 7, Members: 0, Guests: 7)

Who Read This Thread (Total Members: 4)