I tried putting up a menu and waiting it out, Screen saver never kicked in, but I'm not worried too much, I live alone and know better than to leave a menu onscreen
I am curioius though, on the front panel display of the receiver (where the little green/red dish is) before activation it would show info to me (1080, 720P, 480, 480P for example as I cycled thru the resolutions) but after activation it is totally blank, I would expect at least a channel number or something, but all I get is the dish, and when I press a button on the remote, a little flashing LED.....is this the same for everyone?
also had my first total lockup today, was going thru the guide channel by channel, and it froze, had to do a complete power cycle (unplug..LOL) to get it going again......dang waiting for it to aquire programming info is a pain...LOL
also one time so far is has pulled up its main Voom menu by itself, and then cleared it and went back to the show I was watching
Off air channels now mapped correctly, but need better antenna or amplifier (didn't use stealth, used antenna I already have, but still not good enough)