Hi
I have a chieta diseqc 4x1 switch, on port 1 I attached a new dms sw-21k going to a invacom qph I put the circular side on the 22k port and linear on the other. when I did this most of the time the motor wouldn't move the dish if I switch between ports sometimes I could get it to move but I couldn't get any signal.
Remove the switch and it's fine, are these switches any good or is there an incompatibility between chieta/sg2100/sw-21k.
Thanks
I have a chieta diseqc 4x1 switch, on port 1 I attached a new dms sw-21k going to a invacom qph I put the circular side on the 22k port and linear on the other. when I did this most of the time the motor wouldn't move the dish if I switch between ports sometimes I could get it to move but I couldn't get any signal.
Remove the switch and it's fine, are these switches any good or is there an incompatibility between chieta/sg2100/sw-21k.
Thanks