Replacing a actuator motor

[Houston Rockets]

Hello my Venture 36" actuator is starting to turn slow when it has a heavy load on it, I have tried a couple of different IRD's and it is the same..
I am thinking the motor in the actuator is getting weak... My question is how hard is it to replace a Venture 36" actuator motor?

 

[telstar_1]

Probably not a bad motor if still running. The jack may need lubing and/or cleaning. One thing to try might be to pull the motor off the jack and see how it runs on its own, vs. when driving the jack.

 

[Houston Rockets]

Probably not a bad motor if still running. The jack may need lubing and/or cleaning. One thing to try might be to pull the motor off the jack and see how it runs on its own, vs. when driving the jack.

It has the factory boot on it... it only operates slow when a load in on the actuator, like coming up from lower satellites to the higher ones... it is NOT MAKING any noise and it about 10 year old...To me all signs point to a weak motor..going down hill it moves fine only up hill

 

[arlo]

Have the skills to remove the motor and tear it down?
They ain't too hard to do. Makes for a good time to check if the actuator tube is gooked up.
Weak could be that the brushes are toast, armature bearings are dry and the commutator needs a good Scotchbriting and the gearbox grease cleaned and repacked. I have a superrap-jack on it's 10th life.

 

[Houston Rockets]

Have the skills to remove the motor and tear it down?
They ain't too hard to do. Makes for a good time to check if the actuator tube is gooked up.
Weak could be that the brushes are toast, armature bearings are dry and the commutator needs a good Scotchbriting and the gearbox grease cleaned and repacked. I have a superrap-jack on it's 10th life.

Ok

PLEASE LOG IN TO GET RID OF THESE ADS!

 

[telstar_1]

I never repaired actuators as a dealer. They were throwaway, regardless of what went bad. I was just always trying to find the best I could to replace with for longevity & durability, and none were perfect. On some of the Superjacks the rubber wiper seal where the tube runs in & out would go bad in the sun in 1 year and then water went down them and washed out grease & caused corrosion and tube looseness.