Openbox S9 8PSK

[Gray1]

Is Openbox S9 capable of DVB-S2 (8PSK)? I can't get a peep out of the Luken Mux on 137W. Can get the Alaskan channels fine.

Thanks

 

[Mr Tony]

Try this...I know on the Openbox and the Manhattan that mux you have to monkey with the frequency

Its at 4160 H 29125 but for fun change the frequency to 4165 or 4170 and see if it brings them in.
If you do a blind scan they will show up at the right info but then you have to manually change the frequency

Here is my thread about the 87W mux and a note about that 137W mux
http://www.satelliteguys.us/threads...0-mux-on-87W-with-the-6-footer?highlight=3800

 

[Gray1]

Thanks for the reply..Yup I already tried that. 4160, 4165 and 4170 for 29125. Not a peep. It does not blindscan either. 65% on Alaskan..gotta be a reason somewhere.

Thanks again

 

[Magic Static]

I modded the SR a little to 29123. I don't know it was needed but blind scans showed that SR and I used it. 8PSK FEC 3/4

 

[Mr Tony]

maybe try and tweak the dish a little more?

 

[Magic Static]

maybe try and tweak the dish a little more?

Agreed. I have a better S&Q on the Luken MUX than the Alaskan MUX

 

[Gray1]

Dish is tweaked. If I move it up or down or side to side the signal falls off. Even with the dish a little off I should receive some signal..I got nothing. I am using
and older Geosatpro CK1 LNBF. Dont know if that would make a difference. I am low on the horizion maybe signal is blocked somehow. I am about to move on.

Thanks

 

[Mr Tony]

I was able to get it just fine here in Minnesota (so its low on the horizon here too)
can't now because of damn trees